Adding Security with a Tether

A tether anchorage point is provided behind each rear seating position. A child seat that is installed with a seat belt and comes with a tether can use the tether for additional security.

1. Locate the appropriate tether anchorage

1. Locate the appropriate tether anchorage point and lift the cover.

2. Raise the head restraint to its highest position, then route the tether strap through the head restraint legs. Make sure the strap is not twisted.

3. Secure the tether strap hook onto

3. Secure the tether strap hook onto the anchor.

4. Tighten the tether strap as instructed by the child seat manufacturer.

Adding Security with a Tether

Adding Security with a Tether

Since a tether can provide additional security to the lap/shoulder seat belt installation, we recommend using a tether whenever one is available.

    See also:

    How to Refuel
    1. Stop your vehicle with the service station pump on the left side of the vehicle in the rear. 2. Turn off the engine. 3. Push on the fuel fill door release handle at the foot of the driver’ ...

    Safe Driving
    You can find many safety recommendations throughout this chapter, and throughout this manual. ...

    Rear License Plate Light Bulb
    When replacing, use the following bulb. Rear License Plate Light: 5 W 1. Remove the screw from the center of the fastener using a Phillips-head screwdriver. 2. Remove the holding clips using a fl ...