Rear License Plate Light Bulb

When replacing, use the following bulb.

Rear License Plate Light: 5 W

1. Remove the screw from the center of the

1. Remove the screw from the center of the fastener using a Phillips-head screwdriver.

2. Remove the holding clips using a flat-tip screwdriver, then pull the lining back.

3. Remove the license plate light assembly by

3. Remove the license plate light assembly by squeezing the tabs on both sides of the socket.

4. Remove the old bulb and insert a new bulb.

    See also:

    Side Airbags
    The side airbags help protect the upper torso of the driver or a front passenger during a moderate to severe side impact. ...

    Adding Security with a Tether
    A tether anchorage point is provided behind each rear seating position. A child seat that is installed with a seat belt and comes with a tether can use the tether for additional security. 1. Lo ...

    Clock
    Models without navigation system 1. Press the CLOCK (AUX) button until the displayed time begins flashing. 2. Press Preset   (Hour) or (Minute) to set the time. Press Preset   (Reset ...