Front Turn Signal Light Bulbs

When replacing, use the following bulbs.

Front Turn Signal Light: 21 W

1.Turn the steering wheel all the way to the

1.Turn the steering wheel all the way to the opposite side from the light being replaced. Passenger side: Turn the steering wheel to the left. Driver side: Turn the steering wheel to the right.

2. Remove the holding clips (A), (D) and screw, pull the inner fender back.

3. Turn the socket to the left and remove it,

3. Turn the socket to the left and remove it, then remove the old bulb.

4.Insert a new bulb.

Front Turn Signal Light Bulbs

Holding clip (D-type)

When removing the clip, insert a flat-tip screwdriver, then lift and remove the clip.

Insert the clip with the pin raised, and push until it is

Insert the clip with the pin raised, and push until it is flat.

Parking/Side Marker Light Bulbs

    See also:

    Using the Master Door Lock Switch
    Press the master door lock switch in as shown to lock or unlock all doors. Using the Master Door Lock Switch When you lock/unlock either front door using the master door lock switch, all the oth ...

    Climate Control System
    ● Press the AUTO button to activate the climate control system. ● Press the button to turn the system on or off. ● Press the button to defrost the windshield. On models with ...

    Wipers and Washers
    The windshield wipers and washers can be used when the power mode is in ON. MIST The wipers run at high speed until you release the lever. Wiper switch (OFF, INT, LO, HI) Change the wiper swit ...