Driver side

1. Remove the engine compartment cover.

2. Unlock the holding clips (B). Push up the tab, and remove the cover of the air intake duct and its upper part.

Passenger side

All models

3. Remove the holding clip (C) using a flat-tip screwdriver, then remove the upper part of the windshield washer reservoir.

4. Rotate the cover to the left, and remove.

Low Beam Headlights

Holding clip (C-type)

Insert a flat-tip screwdriver, lift and remove the center pin to remove the clip.

Insert the clip with the center pin raised, and push until it is flat.

 

All models

5. Pull the tab to remove the coupler.

6. Rotate the old bulb to the left to remove.

7. Insert a new bulb into the headlight assembly and turn it to the right.

8. Insert the coupler into the connector of the bulb.