Parking/Side Marker Light Bulbs

When replacing, use the following bulbs.

Parking/Side Marker Light: 5 W

Turn the steering wheel and pull the inner fender back in the same way as when replacing the front turn signal light bulbs.

1. Push the tab to remove the coupler.

2.Turn the socket to the left and remove it.

2.Turn the socket to the left and remove it.

3. Remove the old bulb and insert a new bulb.

4. Insert the coupler into the connector of the bulb.

Brake Light, Taillight, Rear Turn SignalLight and Rear Side Marker Light

    See also:

    Adding Engine Oil
    1.Unscrew and remove the engine oil fill cap. 2. Add oil slowly. 3. Reinstall the engine oil fill cap, and tighten it securely. 4.Wait for three minutes and recheck the engine oil dipstick. ...

    Wiper Blades
    ...

    SRS (Supplemental Restraint System) Indicator
    When the power mode is set to ON The indicator comes on for a few seconds, then goes off. This tells you the system is working properly. If the indicator comes on at any other time, or does not ...