If the Keyless Access Remote Battery is Weak
If the beeper sounds, the TO START, HOLD REMOTE NEAR START BUTTON message appears on the multi-information display, the indicator on the ENGINE START/STOP button flashes, and the engine won’t start. Start the engine as follows.
1. Touch the center of the ENGINE START/ STOP button with the A logo on the keyless access remote while the indicator on the ENGINE START/STOP button is flashing. The buttons on the keyless access remote should be facing you.
- The indicator flashes for about 30 seconds.
2. Depress the brake pedal (automatic transmission) or clutch pedal (manual transmission) and press the ENGINE START/STOP button within 10 seconds after the beeper sounds and the indicator stays on.
- If you don’t depress the pedal, the mode will change to ACCESSORY.
See also:
Transmission Fluid
Automatic Transmission Fluid
Specified fluid: Acura ATF DW-1 (automatic transmission fluid)
Check the fluid level when the engine is at normal operating temperature.
1. Park on level ground, and ...
Checking the Engine
If the engine does not start, check the starter.
Checking the Engine
If you must start the vehicle immediately, use an
assisting vehicle to jump start it.
...
Parking/Side Marker Light Bulbs
When replacing, use the following bulbs.
Parking/Side Marker Light: 5 W
Turn the steering wheel and pull the inner
fender back in the same way as when
replacing the front turn signal light bulbs.
...
