Rear License Plate Light Bulb
When replacing, use the following bulb.
Rear License Plate Light: 5 W
1. Remove the screw from the center of the fastener using a Phillips-head screwdriver.
2. Remove the holding clips using a flat-tip screwdriver, then pull the lining back.
3. Remove the license plate light assembly by squeezing the tabs on both sides of the socket.
4. Remove the old bulb and insert a new bulb.
See also:
Charging the Battery
Disconnect both battery cables to prevent damaging your vehicle's electrical
system.
Always disconnect the negative (–) cable first, and reconnect it last.
Battery
WARNING
The battery gives of ...
Playing a USB Flash Drive
Your audio system reads and plays sound files on a USB flash drive in either
MP3, WMA or AAC*1 format.
Connect your USB flash drive to the USB adapter cable, then press the AUX
button.
How to ...
ENGINE START/STOP
Button
Press the button to changes the vehicle's
power mode.
Turn Signals
Turn Signal Control Lever
Lights
Light Control Switches
Wipers and Washers
Wiper/Washer Control Lever
Steerin ...