Front Turn Signal Light Bulbs

When replacing, use the following bulbs.

Front Turn Signal Light: 21 W

1.Turn the steering wheel all the way to the

1.Turn the steering wheel all the way to the opposite side from the light being replaced. Passenger side: Turn the steering wheel to the left. Driver side: Turn the steering wheel to the right.

2. Remove the holding clips (A), (D) and screw, pull the inner fender back.

3. Turn the socket to the left and remove it,

3. Turn the socket to the left and remove it, then remove the old bulb.

4.Insert a new bulb.

Front Turn Signal Light Bulbs

Holding clip (D-type)

When removing the clip, insert a flat-tip screwdriver, then lift and remove the clip.

Insert the clip with the pin raised, and push until it is

Insert the clip with the pin raised, and push until it is flat.

Parking/Side Marker Light Bulbs

    See also:

    Adjusting the Seat Positions
    Adjust the driver's seat as far back as possible while allowing you to maintain full control of the vehicle. You should be able to sit upright, well back in the seat and be able to adequately pres ...

    Tire and Loading Information Label
    The label attached to the driver’s doorjamb provides necessary tire and loading information. Tire and Loading Information Label The tire and loading information label attached to the driver’ ...

    Auxiliary Input Jack
    Use the jack to connect standard audio devices. 1. Open the AUX cover. 2. Connect a standard audio device to the input jack using a 1/8 inch (3.5 mm) stereo miniplug.  - The audio system a ...