High Beam Headlight

Driver side

Driver side

1.Remove the engine compartment cover.

All models

2. Push the tab to remove the coupler.

3. Rotate the old bulb to the left to remove.

4. Insert a new bulb into the headlight assembly and turn it to the right.

5. Insert the coupler into the connector of the bulb.

High Voltage Discharge Types

    See also:

    Brightness Control
    When the power mode is in ON, you can use the brightness control knob to adjust instrument panel brightness. Brighten: Turn the knob to the right. Dim: Turn the knob to the left. You will hear ...

    Turn Signals
    The turn signals can be used when the power mode is in ON. One-touch turn signal When you lightly push up or down and release the turn signal lever, the exterior turn signals and turn signal in ...

    Devices that Emit Radio Waves
    The following products and systems on your vehicle emit radio waves when in operation. Each of the above complies with the appropriate requirements or the required standards of FCC (Federal Commu ...