Engine Compartment Cover

The component parts in the engine compartment are protected by a cover. You may need to remove the cover when you perform certain maintenance work. To remove the cover:

Engine Compartment Cover

Engine Compartment Cover

Holding clip (A-type)

Insert a flat-tip screwdriver, lift and remove the center pin to remove the clip.

Insert the clip with the center pin raised, and push

Insert the clip with the center pin raised, and push until it is flat.

Engine Compartment Cover

Engine Compartment Cover

Holding clip (B-type)

Press down the center pin until it clicks to unlock it.

Push the center pin back to lock the clip. Then, insert

Push the center pin back to lock the clip. Then, insert the clip into the hole and press on the center pin until it is flat.

Recommended Engine Oil

    See also:

    Fuse Locations
    If any electrical devices are not working, set the power mode to VEHICLE OFF (LOCK) and check to see if any applicable fuse is blown. Fuse locations are shown on the fuse box cover. Locate the fu ...

    Using the Remote Transmitter
    Locking the doors Press the LOCK button. Once:  - Some exterior lights flash, all the doors lock, and the security system sets. Twice (within five seconds after the first push):  - ...

    Tire Labeling
    The tires that came on your vehicle have a number of markings. Those you should be aware of are described below. Tire Sizes Whenever tires are replaced, they should be replaced with tires of the ...