Inspecting and Changing Fuses

1. Set the power mode to VEHICLE OFF

1. Set the power mode to VEHICLE OFF (LOCK). Turn headlights and all accessories off.
2. Remove the fuse box cover.
3. Check the large fuse in the engine compartment.
- If the fuse is blown, use a Phillips-head screwdriver to remove the screw and replace it with a new one.

4. Inspect the small fuses in the engine

4. Inspect the small fuses in the engine compartment and the vehicle interior.
- If there is a burned out fuse, remove it with the fuse puller and replace it with a new one.

NOTICE

Replacing a fuse with one that has a higher rating greatly increases the chances of damaging the electrical system.

Replace fuse with a spare fuse of the same specified amperage.

Confirm the specified amperage using the charts.

There is a fuse puller in the engine compartment fuse box located near the brake fluid reservoir.

    See also:

    Making a Call
    You can make calls using any phone number or a name in the HFL phonebook, and redial the last number called. ■ Direct dialing a phone number 1. Say “Call” or “Dial.” 2. Say the numbe ...

    Low Beam Headlights
    Driver side 1. Remove the engine compartment cover. 2. Unlock the holding clips (B). Push up the tab, and remove the cover of the air intake duct and its upper part. Passenger side All mod ...

    VSA® On and Off
    This button is on the driver side control panel. To turn the VSA® system on and off, press and hold it until you hear a beep. VSA® will stop and the indicator will come on. To turn it on ...