How to Set Up the Jack

1. Place the jack under the jacking point

1. Place the jack under the jacking point closest to the tire to be changed.

2. Turn the end bracket (as shown in the

2. Turn the end bracket (as shown in the image) clockwise until the top of the jack contacts the jacking point.
- Make sure that the jacking point tab is resting in the jack notch.

3. Raise the vehicle, using the jack handle

3. Raise the vehicle, using the jack handle bar and the jack handle, until the tire is off the ground.

WARNING

The vehicle can easily roll off the jack, seriously injuring anyone underneath.

Follow the directions for changing a tire exactly, and never get under the vehicle when it is supported only by the jack.

Do not use the jack with people or luggage in the vehicle.

Use the jack provided in your vehicle.

Other jacks may not support the weight (“load”) or may not fit in the jacking point.

The following instructions must be followed to use the jack safely.

• Do not use while the engine is running.
• Use only where the ground is firm and level.
• Use only at the jacking points.
• Do not get in the vehicle while using the jack.
• Do not put anything on top of or underneath the jack.

    See also:

    Unlocking Using the Inner Handle of Front Doors
    Pull the front door inner handle.  - The door unlocks and opens in one motion. Unlocking Using the Inner Handle of Front Doors The inner front door handles are designed to allow front seat ...

    Multi-View Rear Camera
    About Your Multi-View Rear Camera The audio/information screen can display your vehicle’s rear view. The display automatically changes to the rear view when the shift lever is moved to . σ ...

    Turn Signals
    The turn signals can be used when the power mode is in ON. ■ One-touch turn signal When you lightly push up or down and release the turn signal lever, the exterior turn signals and turn ...