Brake Fluid

Specified fluid: Acura Heavy Duty Brake Fluid DOT 3

■Checking the Brake Fluid

The fluid level should be between the MIN

The fluid level should be between the MIN and MAX marks on the side of the reservoir.

NOTICE

Brake fluid marked DOT 5 is not compatible with your vehicle’s braking system and can cause extensive damage.

If the specified brake fluid is not available, you should use only DOT 3 or DOT 4 fluid from a sealed container as a temporary replacement.

Using any non-Acura brake fluid can cause corrosion and decrease the longevity of the system. Have the brake system flushed and refilled with Acura Heavy Duty Brake Fluid DOT 3 as soon as possible.

If the brake fluid level is at or below the MIN mark, have a dealer inspect for leaks or worn brake pads as soon as possible.

    See also:

    Fuse Locations
    If any electrical devices are not working, set the power mode to VEHICLE OFF (LOCK) and check to see if any applicable fuse is blown. ...

    Important Safety Precautions
    Always wear your seat belt A seat belt is your best protection in all types of collisions. Airbags are designed to supplement seat belts, not replace them. So even though your vehicle is equipped ...

    Compass*
    When you turn the ignition switch to ON , the compass self-calibrates, and the compass display appears. Compass operation can be affected under the following conditions: • Driving near power ...