Parking Sensor System*

The corner and center sensors monitor obstacles behind your vehicle, and the beeper and audio/information screen let you know the approximate distance between your vehicle and the obstacle.

■ The sensor location and range

Even when the system is on, always confirm if there is

Even when the system is on, always confirm if there is no obstacle near your vehicle before parking.

The system may not work properly when: • The sensors are covered with snow, ice, mud or dirt.
• The vehicle is on uneven surface, such as grass, bumps, or a hill.
• The vehicle has been out in hot or cold weather.
• The system is affected by some electronic devices that generate ultrasonic wave.
• Driving in bad weather.

The system may not sense: • Thin or low objects.
• Sonic-absorptive materials, such as snow, cotton, or sponge.
• Objects directly under the bumper.

Do not put any accessories on or around the sensors.

■ Parking sensor system on and off

With the power mode in ON, press the

With the power mode in ON, press the parking sensor system button to turn on or off the system. The indicator in the button comes on and the beeper sounds when the system is on.

The rear center and corner sensors start to detect an obstacle when the shift lever is in than 5 mph, and the vehicle speed is less than 5 mph (8 km/h).

The front corner sensors start to detect an obstacle when the shift lever is in any position other than is less, and the vehicle speed is less than 5 mph (8 km/h).

■ When the distance between your vehicle and obstacles behind becomes shorter

■Turning off All Rear Sensors

■Turning off All Rear Sensors

1. Make sure that the parking sensor system is not activated. Set the power mode to VEHICLE OFF (LOCK).
2. Press and hold the parking sensor system button, and set the power mode to ON.
3. Keep pressing the button for ten seconds. Release the button when the indicator in the button flashes.
4. Press the button again. The indicator in the button goes off.
- The beeper sounds twice. The rear sensors are now turned off.

To turn the rear sensors on again, follow the above procedure. The beeper sounds three times when the rear sensors come back on.

When you shift to indicator in the parking, the indicator in the parking sensor system button blinks as a reminder that the rear sensors have been turned off.

    See also:

    Driving
    This chapter discusses driving, refueling, and information on items such as accessories. ...

    Lane Keeping Assist System (LKAS)*
    Provides steering input to help keep the vehicle in the middle of a detected lane and provides audible and visual alerts if the vehicle is detected drifting out of its lane. Important Safety R ...

    iPod®/USB Flash Drive
    If an error occurs while playing an iPod® or USB flash drive, you may see the following error messages. If you cannot clear the error message, contact a dealer. ...