Seat Belt Inspection

Regularly check the condition of your seat belts as follows: • Pull each belt out fully, and look for frays, cuts, burns, and wear.
• Check that the latches work smoothly and the belts retract easily.

- If a belt does not retract easily, cleaning the belt may correct the problem. Only use a mild soap and warm water. Do not use bleach or cleaning solvents. Make sure the belt is completely dry before allowing it to retract.

Any belt that is not in good condition or working properly will not provide proper protection and should be replaced as soon as possible.

A belt that has been worn during a crash may not provide the same level of protection in a subsequent crash. Have your seat belts inspected by a dealer after any collision.

WARNING

Not checking or maintaining seat belts can result in serious injury or death if the seat belts do not work properly when needed.

Check your seat belts regularly and have any problem corrected as soon as possible.

    See also:

    Pandora®
    U.S. models If an error occurs while playing Pandora®, you may see the following error messages. If you cannot clear the error message, contact a dealer. ...

    Checking the Engine
    If the engine does not start, check the starter. Checking the Engine If you must start the vehicle immediately, use an assisting vehicle to jump start it. ...

    Handling the Unexpe
    Flat Tire ● Park in a safe location and replace the flat tire with the compact spare tire in the trunk. Engine Won’t Start ● If the battery is dead, jump start using a booster bat ...