Fastening a Seat Belt

After adjusting a front seat to the proper position, and while sitting upright and well back in the seat:

1. Pull the seat belt out slowly.

1. Pull the seat belt out slowly.

2. Insert the latch plate into the buckle, then

2. Insert the latch plate into the buckle, then tug on the belt to make sure the buckle is secure.
- Make sure that the belt is not twisted or caught on anything.

Models with CMBSTM

When you or the front passenger insert the latch plate into the buckle, the front seat belt retracts automatically.

No one should sit in a seat with an inoperative seat belt or one that does not appear to be working correctly. Using a seat belt that is not working properly may not protect the occupant in a crash.

Have a dealer check the belt as soon as possible.

Never insert any foreign objects into the buckle or retractor mechanism.

3. Position the lap part of the belt as low as

3. Position the lap part of the belt as low as possible across your hips, then pull up on the shoulder part of the belt so the lap part fits snugly. This lets your strong pelvic bones take the force of a crash and reduces the chance of internal injuries.
4. If necessary, pull up on the belt again to remove any slack, then check that the belt rests across the center of your chest and over your shoulder. This spreads the forces of a crash over the strongest bones in your upper body.

WARNING

Improperly positioning the seat belts can cause serious injury or death in a crash.

Make sure all seat belts are properly positioned before driving.

To release the belt, push the red PRESS button then guide the belt by hand until it has retracted completely.

When exiting the vehicle, be sure the belt is out of the way and will not get caught by closing the door.

See also:

Airbag Care
You do not need to, and should not, perform any maintenance on or replace any airbag system components yourself. However, you should have your vehicle inspected by a dealer in the following situatio ...

How to Select a Play Mode
You can select repeat and shuffle modes when playing a file. Interface Dial 1. Press the MENU button. 2. Rotate to select Shuffle/Repeat, then press . 3. Rotate to select a mode, then pre ...

Checking and Maintaining Wiper Blades
Checking Wiper Blades If the wiper blade rubber has deteriorated, it will leave streaks and the metal wiper arm may scratch the window glass. Changing the Wiper Blade Rubber 1. Lift the driver ...