Headlight Bulbs

When replacing, use the following bulbs.

High beam headlight: 60 W (HB3)
Low beam headlight: 55 W (H1 for halogen bulb Type)
35 W (D2S for high voltage discharge type)

■High Beam Headlight

6-cylinder models

6-cylinder models

1. Remove all the engine compartment covers.

Passenger side

All models

2. Remove the engine coolant reservoir.

NOTICE

NOTICE

Halogen bulbs get very hot when lit.

Oil, perspiration, or a scratch on the glass can cause the bulb to overheat and shatter.

The headlight aim is set by the factory, and does not need to be adjusted. However, if you regularly carry heavy items in the trunk or tow a trailer, have the aiming readjusted at a dealer or by a qualified technician.

The HB3 and H1 types are halogen bulbs.

When replacing a bulb, handle it by its base, and protect the glass from contact with your skin or hard objects. If you touch the glass, clean it with denatured alcohol and a clean cloth.

Driver side

Driver side

4-cylinder models

3. Remove the fasteners, using a flat-tip screwdriver. Remove the cover of the air intake duct and its upper part.

6-cylinder models

6-cylinder models

3. Remove the fasteners, and remove the air intake duct cover.

The exterior lights’ inside lenses (headlights, brake lamps, etc.) may fog temporarily after a car wash or while driving in the rain. This does not impact the exterior light function.

However, if you see a large amount of water or ice accumulated inside the lenses, have your vehicle inspected by a dealer.

Driver and passenger side

Driver and passenger side

All models

4. Remove the coupler.
- It can be removed by pushing the tab.
5. Rotate the old bulb to the left to remove.
6. Insert a new bulb into the headlight assembly and turn it to the right.
7. Insert the coupler into the connector of the bulb.

High Voltage Discharge Types

High Voltage Discharge Types

■Low Beam Headlights

High voltage can remain in the circuit for a long period of time after the light is switched off. Do not attempt to inspect or replace the high voltage discharge type bulbs yourself. Ask a dealer to inspect and replace low beam headlights.

Halogen Types

■Low Beam Headlights

1. Turn the steering wheel all the way to

1. Turn the steering wheel all the way to the opposite side from the headlight being replaced.
Passenger side: Turn the steering wheel to the left.
Driver side: Turn the steering wheel to the right.
2. Remove the holding clips and screws, and pull the inner fender back.
3. Rotate the cover to the left, and remove.

Insert a flat-tip screwdriver, lift and remove the

Insert a flat-tip screwdriver, lift and remove the Inner Fender central pin to remove the clip.

4. Unhook the hook, and pull out the connector.

4. Unhook the hook, and pull out the connector.
5. Remove the old bulb and insert the new bulb.
6. Put the connector back into the headlight assembly.

Insert the clip with the central pin raised, and push until it is flat.

Fog Light Bulbs

    See also:

    How to Select a Play Mode
    You can select repeat, random, and scan modes when playing a file(s). 1. Press the MENU button. 2. Rotate to select PLAY MODE, then press . 3. Rotate to select a mode, then press . ■ ...

    Parts and Fluids Used in Maintenance Service
    The use of Acura genuine parts and fluids is recommended when maintaining and servicing your vehicle. Acura genuine parts are manufactured according to the same high quality standards used in Acur ...

    Indicators
    Multi-Information Display Warning and Information Messages. The following messages appear only on the multi-information display. Press the / (information) button to see the ...