Seat Belt Reminder

Your vehicle monitors front seat belt use. If

Your vehicle monitors front seat belt use. If the ignition switch is turned to ON before before the driver’s seat belt is fastened, a beeper will sound and the indicator will blink. If the driver does not fasten the belt before the beeper stops, the indicator will remain on.

The beeper will also periodically sound and the indicator will blink while driving until the driver’s and front passenger’s seat belts are fastened.

The indicator will also come on if a front passenger does not fasten their seat belt within 6 seconds after the ignition switch is turned to ON .

When no one is sitting in the front passenger’s seat, or a child or small adult is riding there, the indicator will not come on.

This is because the weight sensors in the seat cannot detect their presence.

    See also:

    Headlight Bulbs
    When replacing, use the following bulbs. High beam headlight: 60 W (HB3) Low beam headlight: 55 W (H11 for halogen bulb Type) ...

    Engine Compartment Cover
    The component parts in the engine compartment are protected by a cover. You may need to remove the cover when you perform certain maintenance work. To remove the cover: Holding clip (A-type) ...

    Receiving XM® Radio
    Press the (XM®) button and stay in this mode for about 30 minutes until the service is activated. Make sure your vehicle is in an open area with good reception. The XM® satellites are in orbi ...